NETGEAR GSM7228PS - Ip Vrrp (Interface Config); Ip Vrrp Mode

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-26
v1.0, July 2010
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the interface.
The parameter <vrid> is the virtual router ID, which has an integer value range from 1 to 255.
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the
interface. The virtual Router ID, <vrid>, is an integer value that ranges from 1 to 255.
ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the status
field starts a virtual router. The parameter <vrid> is the virtual router ID which has an integer
value ranging from 1 to 255.
no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling the
status field stops a virtual router.
Format ip vrrp <vrid>
Mode Interface Config
Format no ip vrrp <vrid>
Mode Interface Config
Default disabled
Format ip vrrp <vrid> mode
Mode Interface Config
Format no ip vrrp <vrid> mode
Mode Interface Config