NETGEAR GSM7228PS - Snmp-Server Enable Traps Linkmode; Snmp-Server Enable Traps Multiusers

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-45
v1.0, July 2010
no snmp-server enable traps
This command disables the Authentication Flag.
snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are
sent only if the Link Trap flag setting associated with the port is enabled. See “snmp trap link-
status” on page 10-48
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing
terminal interface session.
Format no snmp-server enable traps
Mode Global Config
Note: This command may not be available on all platforms.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
Format no snmp-server enable traps linkmode
Mode Global Config
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config