NETGEAR GSM7228PS - Lldp Med Confignotification; Lldp Med Transmit-Tlv

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-182
v1.0, July 2010
lldp med confignotification
Use this command to configure all the ports to send the topology change notification.
no ldp med confignotification
Use this command to disable notifications.
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set
will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default enabled
Format lldp med confignotification
Mode Interface Config
Format no lldp med confignotification
Mode Interface Config
Default By default, the capabilities and network policy TLVs are included.
Format lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode Interface Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.