Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-28
v1.0, July 2010
show ipv6 vlan
This command displays IPv6 VLAN routing interface addresses.
The rest of the output for this command is displayed in a table with the following column
headings:
show ipv6 traffic
Use this command to show traffic and statistics for IPv6 and ICMPv6. Specify a logical, loopback,
or tunnel interface to view information about traffic on a specific interface. If you do not specify
an interface, the command displays information about traffic on all interfaces.
Format show ipv6 vlan
Modes • Privileged EXEC
• User EXEC
Term Definition
MAC Address
used by
Routing VLANs
Shows the MAC address.
Column
Headings
Definition
VLAN ID The VLAN ID of a configured VLAN.
Logical
Interface
The interface in unit/slot/port format that is associated with the VLAN ID.
IPv6 Address/
Prefix Length
The IPv6 prefix and prefix length associated with the VLAN ID.
Format show ipv6 traffic [{<unit/slot/port> | loopback <loopback-id> | tunnel
<tunnel-id>}]
Mode Privileged EXEC
To Next Page
Loading...
