Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-24
v1.0, July 2010
Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to view
VLAN routing status information.
vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to 4093.
no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4093.
show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.
Preference The preference of the address as a default router address, relative to other router
addresses on the same subnet.
Format vlan routing <vlanid>
Mode VLAN Config
Format no vlan routing <vlanid>
Mode VLAN Config
Format show ip vlan
Modes • Privileged EXEC
• User EXEC
Term Definition
MAC Address
used by Routing
VLANs
The MAC Address associated with the internal bridge-router interface (IBRI). The same
MAC Address is used by all VLAN routing interfaces. It will be displayed above the per-
VLAN information.
Term Definition
To Next Page
Loading...
