NETGEAR GSM7228PS - Ip Ospf Retransmit-Interval; Ip Ospf Transmit-Delay

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-59
v1.0, July 2010
no ip ospf priority
This command sets the default OSPF priority for the specified router interface.
ip ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The retransmit
interval is specified in seconds. The value for <seconds> is the number of seconds between
link-state advertisement retransmissions for adjacencies belonging to this router interface. This
value is also used when retransmitting database description and link-state request packets. Valid
values range from 0 to 3600 (1 hour).
no ip ospf retransmit-interval
This command sets the default OSPF retransmit Interval for the specified interface.
ip ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. The transmit delay is
specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit a link
state update packet over this interface. Valid values for <seconds> range from 1 to 3600 (1
hour).
Format no ip ospf priority
Mode Interface Config
Default 5
Format ip ospf retransmit-interval <0-3600>
Mode Interface Config
Format no ip ospf retransmit-interval
Mode Interface Config
Default 1
Format ip ospf transmit-delay <1-3600>
Mode Interface Config