NETGEAR GSM7228PS - Radius Accounting Mode; Radius Server Attribute

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-53
v1.0, July 2010
radius accounting mode
This command is used to enable the RADIUS accounting function.
no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the
RADIUS accounting function is disabled.
radius server attribute
This command specifies the RADIUS client to use the NAS-IP Address attribute in the RADIUS
requests. If the specific IP address is configured while enabling this attribute, the RADIUS client
uses that IP address while sending NAS-IP-Address attribute in RADIUS communication.
no radius server attribute
The
no version of this command disables the NAS-IP-Address attribute global parameter for
RADIUS client. When this parameter is disabled, the RADIUS client does not send the NAS-IP-
Address attribute in RADIUS requests.
Default disabled
Format radius accounting mode
Mode Global Config
Format no radius accounting mode
Mode Global Config
Format radius server attribute <4> [<ipaddr>]
Mode Global Config
Term Definition
4 NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr The IP address of the server.