Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-34
v1.0, July 2010
Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system time and date
by using SNTP.
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
<url> kernel Downloads a code file by xmodem, zmodem, or TFTP.
<url> {image1 | image2} Download an image from the remote server to either
image. In a stacking environment, the downloaded
image is distributed to the stack nodes.
{image1 | image2} <url> Upload either image to the remote server.
image1 image2 Copy image1 to image2.
image2 image1 Copy image2 to image1.
{image1 | image2} unit://<unit>/{image1 |
image2}
Copy an image from the management node to a given
node in a Stack. Use the unit parameter to specify the
node to which the image should be copied.
{image1 | image2} unit://*/{image1 | image2} Copy an image from the management node to all of the
nodes in a Stack.
Default 6
Format sntp broadcast client poll-interval <poll-interval>
Mode Global Config
Format no sntp broadcast client poll-interval
Mode Global Config
Source Destination Description
To Next Page
Loading...
Need help?
General
