Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-14
v1.0, July 2010
no ip pimdm hello-interval
This command resets the transmission frequency of hello messages between PIM enabled
neighbors to the default value.
show ip pimdm
This command displays the system-wide information for PIM-DM.
show ip pimdm interface
This command displays the interface information for PIM-DM on the specified interface.
Format no ip pimdm hello-interval
Mode Interface Config
Format show ip pimdm
Modes • Privileged EXEC
• User EXEC
Term Definition
Admin Mode Indicates whether PIM-DM is enabled or disabled.
Interface Valid unit, slot, and port number separated by forward slashes.
Interface-Mode Indicates whether PIM-DM is enabled or disabled on this interface.
Operational-
status
The current state of PIM-DM on this interface. Possible values are Operational or Non-
Operational.
Format show ip pimdm interface <unit/slot/port>
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Mode Indicates whether PIM-DM is enabled or disabled on the specified interface.
Hello Interval The frequency at which PIM hello messages are transmitted on this interface. By default,
the value is 30 seconds.
To Next Page
Loading...
