NETGEAR GSM7228PS - Port-Channel Name; Port-Channel System Priority; Show Lacp Actor

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-109
v1.0, July 2010
port-channel name
This command defines a name for the port-channel (LAG). The interface is a logical unit/slot/port
for a configured port-channel, and <name> is an alphanumeric string up to 15 characters.
port-channel system priority
Use this command to configure port-channel system priority. The valid range of <priority> is 0-
65535.
no port-channel system priority
Use this command to configure the default port-channel system priority value.
show lacp actor
Use this command to display LACP actor attributes.
The following output parameters are displayed.
Format port-channel name {<logical unit/slot/port> | all | <name>}
Mode Global Config
Default 0x8000
Format port-channel system priority <priority>
Mode Global Config
Format no port-channel system priority
Mode Global Config
Format show lacp actor {<unit/slot/port>|all}
Mode Global Config
Parameter Description
System Priority The system priority assigned to the Aggregation Port.