Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-22
v1.0, July 2010
no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
spanning-tree edgeport all
This command specifies that every port is an Edge Port within the common and internal spanning
tree. This allows all ports to transition to Forwarding State without delay.
no spanning-tree edgeport all
This command disables Edge Port mode for all ports within the common and internal spanning
tree.
spanning-tree bpduforwarding
Normally a switch will not forward Spanning Tree Protocol (STP) BPDU packets if STP is
disabled. However, if in some network setup, the user wishes to forward BDPU packets received
from other network devices, this command can be used to enable the forwarding.
Format no spanning-tree port mode all
Mode Global Config
Format spanning-tree edgeport all
Mode Global Config
Format no spanning-tree edgeport all
Mode Global Config
Default 2
Format spanning-tree bpduforwarding
Mode Global Config
To Next Page
Loading...
