NETGEAR GSM7228PS - Show Ipv6 Interface

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-21
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 brief
IPv6 Forwarding Mode........................... Enable
IPv6 Unicast Routing Mode...................... Enable
IPv6 Hop Limit................................. 0
ICMPv6 Rate Limit Error Interval............... 1000 msec
ICMPv6 Rate Limit Burst Size................... 100 messages
Maximum Routes................................. 3000
show ipv6 interface
Use this command to show the usability status of IPv6 interfaces and whether ICMPv6 Destination
Unreachable messages may be sent.
If you use the brief parameter, the following information displays for all configured IPv6
interfaces:
If you specify an interface, the following information also appears.
Format show ipv6 interface {brief | <unit/slot/port> |tunnel <0-7> | loopback
<0-7>}
Mode Privileged EXEC
Term Definition
Interface The interface in unit/slot/port format.
IPv6 Routing
Operational
Mode
Shows whether the mode is enabled or disabled.
IPv6 Address/
Length
Shows the IPv6 address and length on interfaces with IPv6 enabled.
Term Definition
IPv6 is enabled Appears if IPv6 is enabled on the interface.
Routing Mode Shows whether IPv6 routing is enabled or disabled.