NETGEAR GSM7228PS - Snmp-Server Community

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-41
v1.0, July 2010
snmp-server
This command sets the name and the physical location of the switch, and the organization
responsible for the network. The range for <name>, <loc> and <con> is from 1 to 31
alphanumeric characters.
snmp-server community
This command adds (and names) a new SNMP community. A community <name> is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privileged level. The length of <name> can be up to 16 case-sensitive characters.
no snmp-server community
This command removes this community name from the table. The <name> is the community
name to be deleted.
Default none
Format snmp-server {sysname <name> | location <loc> | contact <con>}
Mode Global Config
Note: Community names in the SNMP Community Table must be unique. When making
multiple entries using the same community name, the first entry is kept and
processed and all duplicate entries are ignored.
Default • Public and private, which you can rename.
• Default values for the remaining four community names are blank.
Format snmp-server community <name>
Mode Global Config
Format no snmp-server community <name>
Mode Global Config