Managed Switch CLI Manual, Release 8.0.3
Stacking Commands 2-6
v1.0, July 2010
no set slot power
This command unconfigures the power mode of the slot(s) and prohibits power from being
supplied to a card located in the slot. If you specify [all], the command prohibits power to all
slots, otherwise the command prohibits power to the slot identified by <unit/slot>.
Use this command when installing or removing cards. If a card or other module is present in this
slot, power is prohibited to the contents of the slot. If the slot is empty, power is prohibited to any
card inserted into the slot.
reload (Stack)
This command resets the entire stack or the identified <unit>. The <unit> is the switch
identifier. The system prompts you to confirm that you want to reset the switch.
show slot
This command displays information about all the slots in the system or for a specific slot.
Format no set slot power [<unit/slot> | all]
Mode Global Config
Format reload [<unit>]
Mode User EXEC
Format show slot [<unit/slot>]
Mode User EXEC
Term Definition
Slot The slot identifier in a <unit/slot> format.
Slot Status The slot is empty, full, or has encountered an error
Admin State The slot administrative mode is enabled or disabled.
Power State The slot power mode is enabled or disabled.
Configured Card
Model Identifier
The model identifier of the card preconfigured in the slot. Model Identifier is a 32-
character field used to identify a card.
To Next Page
Loading...
