Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-18
v1.0, July 2010
ipv6 mld query-max-response-time
Use this command to set the MLD querier’s maximum response time for the interface and this
value is used in assigning the maximum response time in the query messages that are sent on that
interface. The range for <query-max-response-time> is 0 to 65535 milliseconds.
no ipv6 mld query-max-response-time
This command resets the MLD query max response time for the interface to the default value.
ipv6 mld last-member-query-interval
Use this command to set the last member query interval for the MLD interface, which is the value
of the maximum response time parameter in the group specific queries sent out of this interface.
The range for <last-member-query-interval> is 1 to 65535 milliseconds.
no ipv6 mld last-member-query-interval
Use this command to reset the <last-member-query-interval> parameter of the
interface to the default value.
Default 10000 milliseconds
Format ipv6 mld query-max-response-time <query-max-response-time>
Mode Interface Config
Format no ipv6 mld query-max-response-time
Mode Interface Config
Default 1000 milliseconds
Format ipv6 mld last-member-query-interval <last-member-query-interval>
Mode Interface Config
Format no ipv6 mld last-member-query-interval
Mode Interface Config
To Next Page
Loading...
