NETGEAR GSM7228PS - Deleteport (Global Config)

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-92
v1.0, July 2010
addport
This command adds one port to the port-channel (LAG). The interface is a logical unit/slot/port
number or a group ID of a configured port-channel.
deleteport (Interface Config)
This command deletes the port from the port-channel (LAG). The interface is a logical unit/slot/
port number or a group ID of a configured port-channel.
deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface is a logical
unit/slot/port number of a configured port-channel. To clear the port channels, see “clear port-
channel” on page 9-28
.
Note: Before adding a port to a port-channel, set the physical mode of the port. For more
information, see “speed” on page 3-7
Format addport {<logical unit/slot/port>|<lag-group-id>}
Mode Interface Config
Format deleteport {<logical unit/slot/port>|<lag-group-id>}
Mode Interface Config
Format deleteport <logical unit/slot/port> all
Mode Global Config