Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-52
v1.0, July 2010
redistribute (OSPFv3)
This command configures the OSPFv3 protocol to allow redistribution of routes from the specified
source protocol/routers.
no redistribute(OSPFv3)
This command configures OSPF protocol to prohibit redistribution of routes from the specified
source protocol/routers.
router-id (OSPFv3)
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The
<ipaddress> is a configured value.
trapflags (OSPFv3)
Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or
enable all the trap flags at a time. The different groups of trapflags, and each group’s specific
trapflags to enable or disable, are listed in <Cross-Ref>Table 2.
Default • metric—unspecified
• type—2
• tag—0
Format redistribute {static | connected} [metric <0-16777214>] [metric-type
{1 | 2}] [tag <0-4294967295>]
Mode Router OSPFv3 Config
Format no redistribute {static | connected} [metric] [metric-type] [tag]
Mode Router OSPFv3 Config
Format router-id <ipaddress>
Mode Router OSPFv3 Config
To Next Page
Loading...
