NETGEAR GSM7228PS - Ip Ssh Protocol; Ip Ssh Server Enable; Sshcon Maxsessions

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-17
v1.0, July 2010
ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
ip ssh server enable
This command enables the IP secure shell server.
no ip ssh server enable
This command disables the IP secure shell server.
sshcon maxsessions
This command specifies the maximum number of SSH connection sessions that can be
established. A value of 0 indicates that no ssh connection can be established. The range is 0 to 5.
Format ip ssh
Mode Privileged EXEC
Default 1 and 2
Format ip ssh protocol [1] [2]
Mode Privileged EXEC
Default disabled
Format ip ssh server enable
Mode Privileged EXEC
Format no ip ssh server enable
Mode Privileged EXEC
Default 5
Format sshcon maxsessions <0-5>
Mode Privileged EXEC