NETGEAR GSM7228PS - Enable (Ospf); Network Area (Ospf)

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-40
v1.0, July 2010
enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
network area (OSPF)
Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of an
interface is covered by this network command.
no network area (OSPF)
Use this command to disable the OSPFv2 on a interface if the IP address of an interface was earlier
covered by this network command.
Default enabled
Format enable
Mode Router OSPF Config
Format no enable
Mode Router OSPF Config
Default disabled
Format network <ip-address> <wildcard-mask> area <area-id>
Mode Router OSPF Config
Format no network <ip-address> <wildcard-mask> area <area-id>
Mode Router OSPF Config