NETGEAR GSM7228PS - Transport Input Telnet; Transport Output Telnet

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-12
v1.0, July 2010
transport input telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can be established
until there are no more sessions available. An established session remains active until the session
is ended or an abnormal network error ends the session.
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
transport output telnet
This command regulates new outbound Telnet connections. If enabled, new outbound Telnet
sessions can be established until the system reaches the maximum number of simultaneous
outbound Telnet sessions allowed. An established session remains active until the session is ended
or an abnormal network error ends it.
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be established.
Use the ip telnet server enable command to enable Telnet Server
Admin Mode.
Default enabled
Format transport input telnet
Mode Line Config
Format no transport input telnet
Mode Line Config
Default enabled
Format transport output telnet
Mode Line Config