NETGEAR GSM7228PS - Ipv6 Mld Query-Interval

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-17
v1.0, July 2010
no ipv6 mld router
Use this command, in the administrative mode of the router, to disable MLD in the router.
ipv6 mld query-interval
Use this command to set the MLD router’s query interval for the interface. The query-interval is
the amount of time between the general queries sent when the router is the querier on that
interface. The range for <query-interval> is 1 to 3600 seconds.
no ipv6 mld query-interval
Use this command to reset the MLD query interval to the default value for that interface.
Default Disabled
Format ipv6 mld router
Mode Global Config
Interface Config
Default Disabled
Format no ipv6 mld router
Mode Global Config
Interface Config
Default 125
Format ipv6 mld query-interval <query-interval>
Mode Interface Config
Format no ipv6 mld query-interval
Mode Interface Config