Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-9
v1.0, July 2010
show interface
This command displays a summary of statistics for a specific interface or a count of all CPU traffic
based upon the argument.
The display parameters, when the argument is <unit/slot/port>, are as follows:
The display parameters, when the argument is “switchport” are as follows:
Format show interface {<unit/slot/port> | switchport}
Mode Privileged EXEC
Parameters Definition
Packets
Received
Without Error
The total number of packets (including broadcast packets and multicast packets) received
by the processor.
Packets
Received With
Error
The number of inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol.
Broadcast
Packets
Received
The total number of packets received that were directed to the broadcast address. Note
that this does not include multicast packets.
Packets
Transmitted
Without Error
The total number of packets transmitted out of the interface.
Transmit
Packets Errors
The number of outbound packets that could not be transmitted because of errors.
Collisions
Frames
The best estimate of the total number of collisions on this Ethernet segment.
Time Since
Counters Last
Cleared
The elapsed time, in days, hours, minutes, and seconds since the statistics for this port
were last cleared.
Term Definition
Packets
Received
Without Error
The total number of packets (including broadcast packets and multicast packets) received
by the processor.
Broadcast
Packets
Received
The total number of packets received that were directed to the broadcast address. Note
that this does not include multicast packets.
To Next Page
Loading...
Need help?
General
