Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-63
v1.0, July 2010
timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both
parameters is 0-65535 seconds.
trapflags (OSPF)
Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or
enable all the trap flags at a time. The different groups of trapflags, and each group’s specific
trapflags to enable or disable, are listed in <Cross-Ref>Table 1.
Table 1: Trapflags Groups
• To enable the individual flag, enter the group name followed by that particular flag.
• To enable all the flags in that group, give the group name followed by all.
Default • delay-time—5
• hold-time—10
Format timers spf <delay-time> <hold-time>
Mode Router OSPF Config
Group Flags
errors • authentication-failure
• bad-packet
• config-error
• virt-authentication-failure
• virt-bad-packet
• virt-config-error
if-rx ir-rx-packet
lsa • lsa-maxage
• lsa-originate
overflow • lsdb-overflow
• lsdb-approaching-overflow
retransmit • packets
• virt-packets
rtb • rtb-entry-info
state-change • if-state-change
• neighbor-state-change
• virtif-state-change
• virtneighbor-state-change
To Next Page
Loading...
