EasyManua.ls Logo

NETGEAR GSM7228PS - MAC Access Control List (ACL) Commands; Show Service-Policy

NETGEAR GSM7228PS
788 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-32
v1.0, July 2010
show service-policy
This command displays a summary of policy-oriented statistics information for all interfaces in the
specified direction.
The following information is repeated for each interface and direction (only those interfaces
configured with an attached policy are shown):
MAC Access Control List (ACL) Commands
This section describes the commands you use to configure MAC ACL settings. MAC ACLs
ensure that only authorized users have access to specific resources and block any unwarranted
attempts to reach network resources.
The following rules apply to MAC ACLs:
The maximum number of ACLs you can create is hardware dependent. The limit applies to all
ACLs, regardless of type.
The system supports only Ethernet II frame types.
The maximum number of rules per MAC ACL is hardware dependent.
For the GSM7328Sv1, GSM7352Sv1, and GSM7328FS, if you configure an IP ACL on an
interface, you cannot configure a MAC ACL on the same interface.
In Discarded
Packets
A count of the packets discarded for this class instance for any reason due to DiffServ
treatment of the traffic class.
Format show service-policy in
Mode Privileged EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Operational
Status
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface.
Term Definition

Table of Contents

Other manuals for NETGEAR GSM7228PS

Related product manuals