Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-23
v1.0, July 2010
Routing Mode................................... Disabled
Administrative Mode............................ Enabled
IPv6 Routing Operational Mode.................. Disabled
Bandwidth...................................... 100000 kbps
Interface Maximum Transmit Unit................ 1500
Router Duplicate Address Detection Transmits... 1
Router Advertisement NS Interval............... 0
Router Advertisement Lifetime.................. 1800
Router Advertisement Reachable Time............ 0
Router Advertisement Interval.................. 600
Router Advertisement Managed Config Flag....... Disabled
Router Advertisement Other Config Flag......... Disabled
Router Advertisement Suppress Flag............. Disabled
IPv6 Destination Unreachables.................. Enabled
No IPv6 prefixes configured.
If an IPv6 prefix is configured on the interface, the following information also appears.
show ipv6 neighbor
Use this command to display information about the IPv6 neighbors.
Term Definition
IFPv6 Prefix is The IPv6 prefix for the specified interface.
Preferred
Lifetime
The amount of time the advertised prefix is a preferred prefix.
Valid Lifetime The amount of time the advertised prefix is valid.
Onlink Flag Shows whether the onlink flag is set (enabled) in the prefix.
Autonomous
Flag
Shows whether the autonomous address-configuration flag (autoconfig) is set (enabled)
in the prefix.
Format show ipv6 neighbor
Mode Privileged EXEC
Term Definition
Interface The interface in unit/slot/port format.
To Next Page
Loading...
Need help?
General
