NETGEAR GSM7228PS - Set Mld Maxresponse

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-157
v1.0, July 2010
set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a switch
will wait after sending a query on an interface because it did not receive a report for a particular
group in that interface. This value must be less than the MLD Query Interval time value. The range
is 1 to 65 seconds.
no set mld maxresponse
Use this command to set the max response time (on the interface or VLAN) to the default value.
Format no set mld groupmembership-interval
Mode • Interface Config
• Global Config
Default 10 seconds
Format set mld maxresponse <1-65>
Mode • Global Config
• Interface Config
Default 10 seconds
Format set mld maxresponse <vlanid> <1-65>
Mode • VLAN Mode
Format no set mld maxresponse
Mode • Global Config
• Interface Config
Format no set mld maxresponse <vlanid>
Mode • VLAN Mode