Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-7
v1.0, July 2010
show eventlog
This command displays the event log, which contains error messages from the system. The event
log is not cleared on a system reset. The <unit> is the switch identifier.
show hardware
This command displays inventory information for the switch.
Format show eventlog [<unit>]
Mode Privileged EXEC
Term Definition
File The file in which the event originated.
Line The line number of the event.
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
Unit The unit for the event.
Note: Event log information is retained across a switch reset.
Note: The show version command and the show hardware command display the same
information. In future releases of the software, the show hardware command will
not be available. For a description of the command output, see the command “show
version” on page 9-8.
Format show hardware
Mode Privileged EXEC
To Next Page
Loading...
