Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-47
v1.0, July 2010
This command specified in Interface Config mode only affects a single interface, whereas the
Global Config mode setting is applied to all interfaces. The vlan keyword is only valid in the
Global Config mode. The Interface Config mode command is only available on platforms that
support independent per-port class of service queue configuration.
no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the interface(s) in a given
direction.
show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL.
Use the [name] parameter to identify a specific IPv6 ACL to display.
Note: You should be aware that the <out> option may or may not be available,
depending on the platform.
Format ipv6 traffic-filter <name> [vlan <vlan-id>] <in | out>[sequence <1-
4294967295>]
Modes • Global Config
• Interface Config
Format no ipv6 traffic-filter <name> [vlan <vlan-id>] in [sequence <1-
4294967295>]
Modes • Global Config
• Interface Config
Format show ipv6 access-lists [name]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within the IPv6 ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
To Next Page
Loading...
Need help?
General
