Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-201
v1.0, July 2010
no dos-control tcpfinurgpsh
This command sets disables TCP FIN and URG and PSH and SEQ=0 checking Denial of Service
protections. This command is only available on FSM72xxRS switches.
dos-control icmpv4
dos-control icmpv4
This command enables Maximum ICMPv4 Packet Size Denial of Service protections. If the mode
is enabled, Denial of Service prevention is active for this type of attack. If ICMPv4 Echo Request
(PING) packets ingress having a size greater than the configured value, the packets will be
dropped if the mode is enabled. This command is only available on FSM72xxRS switches.
no dos-control icmpv4
This command disables Maximum ICMP Packet Size Denial of Service protections. This
command is only available on FSM72xxRS switches.
Format dos-control tcpfinurgpsh
Mode Global Config
Format no dos-control tcpfinurgpsh
Mode Global Config
Default disabled <512>
Format dos-control icmpv4 <0-16384>
Mode Global Config
Format no dos-control icmpv4
Mode Global Config
To Next Page
Loading...
Need help?
General
