Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-48
v1.0, July 2010
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
snmp trap link-status
This command enables link status traps by interface.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple
entries using the same IP address, the first entry is retained and processed. All
duplicate entries are ignored.
Format snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Mode Global Config
Format snmptrap mode <name> <ipaddr>
Mode Global Config
Format no snmptrap mode <name> <ipaddr>
Mode Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-
server enable traps linkmode” on page 10-45
To Next Page
Loading...
