Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-29
v1.0, July 2010
no ip vrrp priority
This command sets the default priority value for the virtual router configured on a specified
interface.
ip vrrp timers advertise
This command sets the frequency, in seconds, that an interface on the specified virtual router sends
a virtual router advertisement.
no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
ip vrrp track interface
Use this command to alter the priority of the VRRP router based on the availability of its
interfaces. This command is useful for tracking interfaces that are not configured for VRRP. Only
IP interfaces are tracked. A tracked interface is up if the IP on that interface is up. Otherwise, the
tracked interface is down.
When the tracked interface is down or the interface has been removed from the router, the priority
of the VRRP router will be decremented by the value specified in the <priority> argument. When
the interface is up for IP protocol, the priority will be incremented by the <priority> value.
A VRRP configured interface can track more than one interface. When a tracked interface goes
down, then the priority of the router will be decreased by 10 (the default priority decrement) for
each downed interface. The default priority decrement is changed using the <priority> argument.
Format no ip vrrp <vrid> priority
Mode Interface Config
Default 1
Format ip vrrp <vrid> timers advertise <1-255>
Mode Interface Config
Format no ip vrrp <vrid> timers advertise
Mode Interface Config
To Next Page
Loading...
