Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-68
v1.0, July 2010
no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is “auto” or “mac-based”. If the control mode is not
“auto” or “mac-based”, an error will be returned.
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format no dot1x port-control all
Mode Global Config
Format dot1x re-authenticate <unit/slot/port>
Mode Privileged EXEC
Default disabled
Format dot1x re-authentication
Mode Interface Config
Format no dot1x re-authentication
Mode Interface Config
To Next Page
Loading...
