NETGEAR GSM7228PS - Set Mld Mcrtexpiretime; Set Mld Mrouter

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-158
v1.0, July 2010
set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN. This is the amount of time in seconds that a switch
waits for a query to be received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates
an infinite timeout, i.e. no expiration.
no set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time to 0. The time is set for the
system, on a particular interface or a VLAN.
set mld mrouter
Use this command to configure the VLAN ID for the VLAN that has the multicast router attached
mode enabled.
Default 0
Format set mld mcrtexpiretime <0-3600>
Mode • Global Config
• Interface Config
Default 0
Format set mld mcrtexpiretime <vlanid> <0-3600>
Mode • VLAN Config
Format no set mld mcrtexpiretime
Mode • Global Config
• Interface Config
Format no set mld mcrtexpiretime <vlanid>
Mode • VLAN Mode
Format set mld mrouter <vlanid>
Mode Interface Config