NETGEAR GSM7228PS - Ipv6 PIM-SM Commands; Ipv6 Pimsm Bsr-Border; Ipv6 Pimsm Bsr-Candidate

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-8
v1.0, July 2010
10.1.37.2 0/24 1 30
--------- ------- --------- -------
IPv6 PIM-SM Commands
This section describes the PIM-SM commands you use to configure Protocol Independent
Multicast - Sparse Mode (PIM-SM) in IPv6.
ipv6 pimsm bsr-border
Use this command to prevent bootstrap router (BSR) messages from being sent or received
through an interface.
no ipv6 pimsm bsr-border
Use this command to disable the interface from being the BSR border.
ipv6 pimsm bsr-candidate
This command is used to configure the router to announce its candidacy as a bootstrap router
(BSR).
Default disabled
Format ipv6 pimsm bsr-border
Mode Interface Config
Format no ipv6 pimsm bsr-border
Mode Interface Config
Default None
Format ipv6 pimsm bsr-candidate interface <unit/slot/port> [hash-mask-
length] [priority]
Mode Global Config