NETGEAR GSM7228PS - Show Captive-Portal Configuration Locales

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-18
v1.0, July 2010
Example
(switch)#show captive-portal configuration status
CP ID CP Name Mode Protocol Verification
----- ---------- -------- -------- ------------
1 cp1 Enable https Guest
2 cp2 Enable http Local
3 cp3 Disable https Guest
(switch)#show captive-portal configuration 1 status
CP ID.......................................... 1
CP Name........................................ cp1
Mode........................................... Enabled
Protocol Mode.................................. https
Verification Mode.............................. Guest
Group Name..................................... group123
Redirect URL Mode.............................. Enabled
Redirect URL................................... www.cnn.com
Session Timeout (seconds)...................... 86400
Idle Timeout (seconds)......................... 600
Max Bandwidth Up (bytes/sec)................... 0
Max Bandwidth Down (bytes/sec)................. 0
Max Input Octets (bytes)....................... 0
Max Output Octets (bytes)...................... 0
Max Total Octets (bytes)....................... 0
show captive-portal configuration locales
Use this command to display locales associated with a specific captive portal configuration. <1-
10> is captive port ID.
Example
(switch)#show captive-portal configuration 1 locales
Locale Code
---------------
En
Format show captive-portal configuration <1-10> locales
Mode Privileged EXEC mode