Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-6
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pimdm
Admin Mode..................................... Enable
PIM-DM INTERFACE STATUS
Interface Interface Mode Protocol State
--------- -------------- ----------------
0/1 Enable Non-Operational
0/2 Enable Non-Operational
show ipv6 pimdm neighbor
Use this command to display the PIM-DM neighbor information for all interfaces or for the
specified interface.
Format show ipv6 pimdm
Mode • Privileged EXEC
• User EXEC
Term Definition
Admin Mode Indicates whether PIM-DM is enabled or disabled.
Interface Valid unit, slot, and port number separated by forward slashes.
Interface-Mode Indicates whether PIM-DM is enabled or disabled on this interface.
Operational-
Status
The current state of PIM-DM on this interface. Possible values are Operational or Non-
Operational.
Format show ipv6 pimdm neighbor [<unit/slot/port>|all]
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Neighbor
Address
The IP address of the neighbor on an interface.
To Next Page
Loading...
