Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-40
v1.0, July 2010
show clock
This command is used to display the time information.
DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the switch.
DHCP uses UDP as its transport protocol and supports a number of features that facilitate in
administration address allocations.
Last Attempt
Time
Last server attempt time for the specified server.
Last Update
Status
Last server attempt status for the server.
Total Unicast
Requests
Number of requests to the server.
Failed Unicast
Requests
Number of failed requests from server.
Format show clock [detail]
Mode Privileged EXEC
Term Definition
Time The time provided by the time source.
Time Source The time source type.
If option detail is specified, these terms are displayed
Time Zone The time zone configured.
Summer Time Indicate if the summer time is enabled.
Term Definition
To Next Page
Loading...
