Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-39
v1.0, July 2010
no ip helper-address discard
Use this command to permit the matching packets.
show ip helper-address
Use this command to display the configured helper addresses on the given interface.
The following shows example CLI display output for the command.
(switch) #show ip helper-address 1/0/1
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5
Open Shortest Path First (OSPF) Commands
This section describes the commands you use to view and configure OSPF, which is a link-state
routing protocol that you use to route traffic within a network.
router ospf
Use this command to enter Router OSPF mode.
Format no ip helper-address discard
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode Interface Config
Format show ip helper-address <interface>
Mode • Privileged EXEC
• User EXEC
Format router ospf
Mode Global Config
To Next Page
Loading...
