NETGEAR GSM7228PS - Chapter 7 Ipv6 Commands; Ipv6 Management Commands; Network Ipv6 Address; Network Ipv6 Enable

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-2
v1.0, July 2010
IPv6 Management Commands
IPv6 Management commands allow a device to be managed via an IPv6 address in a switch or
IPv4 routing (i.e., independent from the IPv6 Routing package). For Routing/IPv6 builds of
Switch CLI dual IPv4/IPv6 operation over the service port is enabled. Switch CLI has capabilities
such as:
• Static assignment of IPv6 addresses and gateways for the network ports.
• The ability to ping an IPv6 link-local address over the network port.
• Using IPv6 Management commands, you can send SNMP traps and queries via the network
port.
• The user can manage a device via the network port (in addition to a Routing Interface).
network ipv6 enable
Use this command to enable IPv6 operation on the network port.
no network ipv6 enable
Use this command to disable IPv6 operation on the network port.
network ipv6 address
Use this command to configure IPv6 global addressing (i.e. default routers) information for the
network port.
Default enabled
Format network ipv6 enable
Mode Privileged EXEC
Format no network ipv6 enable
Mode Privileged EXEC
Format network ipv6 address <address>/<prefix-length> [eui64]
Mode Privileged EXEC