NETGEAR GSM7228PS - Ip Pimsm Register-Threshold; Ip Pimsm Rp-Address

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-20
v1.0, July 2010
ip pimsm register-threshold
This command configures the Register Threshold rate for the Rendezvous Point router to switch to
a source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec).
no ip pimsm register-threshold
This command resets the register threshold rate for the Rendezvous Pointer router to the default
value.
ip pimsm rp-address
This command is used to statically configure the RP address for one or more multicast groups. The
parameter <rp-address> is the IP address of the RP. The parameter <groupaddress> is the
group address supported by the RP. The parameter <groupmask> is the group mask for the
group address. The optional keyword override indicates that if there is a conflict, the RP
configured with this command prevails over the RP learned by BSR.
no ip pimsm rp-address
This command is used to statically remove the RP address for one or more multicast groups.
Default 0
Format ip pimsm register-threshold <0-2000>
Mode Global Config
Format no ip pimsm register-threshold
Mode Global Config
Default none
Format ip pimsm rp-address <rp-address> <group-address> <group-mask>
[override]
Mode Global Config
Format no ip pimsm rp-address <rp-address> <group-address> <group-mask>
Mode Global Config