NETGEAR GSM7228PS - Dos-Control Icmp; Dos-Control Smacdmac

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-196
v1.0, July 2010
no dos-control l4port
This command disables L4 Port Denial of Service protections.
dos-control icmp
This command enables Maximum ICMP Packet Size Denial of Service protections. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If ICMP Echo Request
(PING) packets ingress having a size greater than the configured value, the packets will be
dropped if the mode is enabled.
no dos-control icmp
This command disables Maximum ICMP Packet Size Denial of Service protections.
dos-control smacdmac
This command enables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for this
type of attack. If packets ingress with SMAC=DMAC, the packets will be dropped if the mode is
enabled. This command is only available on FSM72xxRS switches.
Format no dos-control l4port
Mode Global Config
Default disabled <512>
Format dos-control icmp [<0-1023>]
Mode Global Config
Format no dos-control icmp
Mode Global Config
Default disabled
Format dos-control smacdmac
Mode Global Config