Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-197
v1.0, July 2010
no dos-control smacdmac
This command disables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection. This command is only available on FSM72xxRS switches.
dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port =Destination
TCP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with Source TCP Port =Destination TCP Port, the
packets will be dropped if the mode is enabled. This command is only available on FSM72xxRS
switches.
no dos-control tcpport
This command disables TCP L4 source = destination port number (Source TCP Port =Destination
TCP Port) Denial of Service protection. This command is only available on FSM72xxRS switches.
dos-control udpport
This command enables UDP L4 source = destination port number (Source UDP Port =Destination
UDP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with Source UDP Port =Destination UDP Port, the
packets will be dropped if the mode is enabled. This command is only available on FSM72xxRS
switches.
Format no dos-control smacdmac
Mode Global Config
Default disabled
Format dos-control tcpport
Mode Global Config
Format no dos-control smacdmac
Mode Global Config
To Next Page
Loading...
