Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-143
v1.0, July 2010
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular interface
or VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait
after sending a query on an interface because it did not receive a report for a particular group in
that interface. This value must be less than the IGMP Query Interval time value. The range is 1 to
25 seconds.
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time. The time is set for the system, on
a particular interface or VLAN. This is the amount of time in seconds that a switch waits for a
query to be received on an interface before the interface is removed from the list of interfaces with
multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-
out, i.e. no expiration.
Default 10 seconds
Format set igmp maxresponse <1-25>
Mode • Global Config
• Interface Config
Format set igmp maxresponse <vlan_id> <1-25>
Mode VLAN Config
Format no set igmp maxresponse
Mode • Global Config
• Interface Config
Format no set igmp maxresponse <vlan_id>
Mode VLAN Config
Default 0
To Next Page
Loading...
