NETGEAR GSM7228PS - Ip Dhcp Excluded-Address

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-48
v1.0, July 2010
option
The option command configures DHCP Server options. The <code> parameter specifies the
DHCP option code and ranges from 1-254. The <ascii string> parameter specifies an NVT
ASCII character string. ASCII character strings that contain white space must be delimited by
quotation marks. The hex <string> parameter specifies hexadecimal data. In hexadecimal,
character strings are two hexadecimal digits. You can separate each byte by a period (for example,
a3.4f.22.0c), colon (for example, a3:4f:22:0c), or white space (for example, a3 4f 22
0c).
no option
This command removes the DHCP Server options. The <code> parameter specifies the DHCP
option code.
ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP clients.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Default none
Format option <code> {ascii string | hex <string1> [<string2>...<string8>] |
ip <address1> [<address2>...<address8>]}
Mode DHCP Pool Config
Format no option <code>
Mode DHCP Pool Config
Default none
Format ip dhcp excluded-address <lowaddress> [highaddress]
Mode Global Config