Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-38
v1.0, July 2010
vlan protocol group add protocol
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>.
A group may have more than one protocol associated with it. Each interface and protocol
combination can only be associated with one group. If adding a protocol to a group causes any
conflicts with interfaces currently associated with the group, this command fails and the protocol
is not added to the group. The possible values for protocol are ip, arp, and ipx.
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is
identified by this <groupid>. The possible values for protocol are ip, arp, and ipx.
vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this <groupid>.
protocol group
This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>.
A group may only be associated with one VLAN at a time, however the VLAN association can be
changed.
Default none
Format vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
Format no vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
Format vlan protocol group remove <groupid>
Mode Global Config
To Next Page
Loading...
