Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-102
v1.0, July 2010
lacp partner system id
Use this command to configure the 6-octet MAC Address value representing the administrative
value of the Aggregation Port’s protocol Partner’s System ID. The valid range of <system-id>
is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
no lacp partner system id
Use this command to configure the default value representing the administrative value of the
Aggregation Port’s protocol Partner’s System ID.
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner’s System ID. The valid range for <priority> is 0 to 255.
Default 00:00:00:00:00:00
Format lacp partner system id <system-id>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner system id
Mode Interface Config
Default 0x0
Format lacp partner system priority <priority>
Mode Interface Config
To Next Page
Loading...
