Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-7
v1.0, July 2010
no name
Use this command to remove a configuration name.
protocol
Use this command to configure the protocol mode for a captive portal configuration. The default
protocol is http.
verification
Use this command to configure the verification mode for a captive portal configuration. User
verification can be configured to allow access for guest users; users that do not have assigned user
names and passwords. User verification can also be configured to allow access for authenticated
users. Authenticated users are required to enter a valid user name and password that must first be
validated against the local database or a RADIUS server. Network access is granted once user
verification has been confirmed.
Format no name
Mode Captive Portal Instance mode
Default http
Format protocol { http | https }
Mode Captive Portal Instance mode
Default guest
Format verification { guest | local | radius }
Mode Captive Portal Instance mode
To Next Page
Loading...
