Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-69
v1.0, July 2010
service dhcpv6
This command enables DHCPv6 configuration on the router.
no service dhcpv6
This command disables DHCPv6 configuration on router.
ipv6 dhcp server
Use this command to configure DHCPv6 server functionality on an interface. The <pool-
name> is the DHCPv6 pool containing stateless and/or prefix delegation parameters, rapid-
commit is an option that allows for an abbreviated exchange between the client and server, and
<pref-value> is a value used by clients to determine preference between multiple DHCPv6
servers. For a particular interface DHCPv6 server and DHCPv6 relay functions are mutually
exclusive.
ipv6 dhcp relay destination
Use this command to configure an interface for DHCPv6 relay functionality. Use the
destination keyword to set the relay server IPv6 address. The <relay-address>
parameter is an IPv6 address of a DHCPv6 relay server. Use the interface keyword to set the
relay server interface. The <relay-interface> parameter is an interface (unit/slot/port) to
reach a relay server. The optional remote-id is the Relay Agent Information Option “remote
ID” sub-option to be added to relayed messages.This can either be the special keyword duid-
ifid, which causes the “remote ID” to be derived from the DHCPv6 server DUID and the relay
interface number, or it can be specified as a user-defined string.
Default disabled
Format service dhcpv6
Mode Global Config
Format no service dhcpv6
Mode Global Config
Format ipv6 dhcp server <pool-name> [rapid-commit] [preference <pref-value>]
Mode Interface Config
To Next Page
Loading...
