NETGEAR GSM7228PS - Page 758

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-30
v1.0, July 2010
If the user ID is specified, the following terms are displayed.
Example
(switch)#show captive-portal user
Format show captive-portal user [ <1-128> ]
Mode Privileged EXEC mode
Term Definition
User ID The user ID
User Name The user name
Session Timeout Logout once session timeout is reached (seconds). If the value is 0 then use the value
configured for the captive portal.
Idle Timeout Logout once idle timeout is reached (seconds). If the attribute is 0 then use the value
configured for the captive portal.
Group ID The group ID associated with the user
Group Name The group name
Term Definition
Password
Configured
If the password is configured.
Max Bandwidth Up
(bytes/sec)
Maximum client transmit rate(b/s). Limits the bandwidth at which the client can send
data into the network. If the value is 0 then use the value configured for the captive
portal.
Max Bandwidth
Down (bytes/sec)
Maximum client receive rate (b/s). Limits the bandwidth at which the client can receive
data from the network. If the value is 0 or then use the value configured for the captive
portal.
Max Input Octets
(bytes)
Maximum number of octets the user is allowed to transmit.After this limit has been
reached the user will be disconnected. If the value is 0 then use the value configured for
the captive portal.
Max Output Octets
(bytes)
Maximum number of octets the user is allowed to receive. After this limit has been
reached the user will be disconnected. If the attribute is 0 then use the value configured
for the captive portal.
Max Total Octets
(bytes)
Maximum number of octets the user is allowed to transfer (sum of octets transmitted
and received). After this limit has been reached the user will be disconnected. If the
value is 0 then use the value configured for the captive portal.