Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-117
v1.0, July 2010
no macfilter adddest
This command removes a port from the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
macfilter adddest all
This command adds all interfaces to the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
no macfilter adddest all
This command removes all ports from the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
Format no macfilter adddest <macaddr> <vlanid>
Mode Interface Config
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format macfilter adddest all <macaddr> <vlanid>
Mode Global Config
Format no macfilter adddest all <macaddr> <vlanid>
Mode Global Config
To Next Page
Loading...
